Barkbusters | Barkbusters BHG-115-00-NP Hardware Kit – Two Point Mount for BMW F 900 GS / F 900 GS Enduro

Barkbusters Hardware Kit – Two Point Mount for BMW F 900 GS / F 900 GS Enduro – BHG-115-00-NP - Barkbusters

The Barkbusters BHG-115-00-NP Two Point Mount Hardware Kit is designed specifically for the BMW F 900 GS and BMW F 900 GS Enduro. It features a strong, heat-treated aluminium backbone secured at two mounting points for enhanced protection around the handlebar and controls.

Features

• Bike-specific two-point handguard mounting system
• Designed for OEM specifications
• Full wrap-around aluminium backbone design
• Heat-treated aluminium backbone for added strength and impact protection
• Black powder-coated backbone
• Bar end weights included
• Easy installation
• Compatible with JET, VPS, STORM, and CARBON guards, each sold separately
• Hardware kit only – plastic guards are not included

Compatibility

• BMW F 900 GS (2024 onwards)
• BMW F 900 GS Enduro (2024 onwards)

Required Accessories

This product consists of the hardware and mounting system only. Plastic guards are not included and must be purchased separately.

The BHG-115-00-NP hardware kit is compatible with Barkbusters JET, VPS, STORM, and CARBON guards.

Product Specifications

Material: Heat-treated aluminium

Backbone Finish: Powder-coated black

Mounting System: Two-point mount

Bar End Weights: Included

Fitting Procedure

The fitting procedure shown is for the right side. Repeat the installation for the left side using the applicable parts.

• Loosely assemble the clamp and connector to the handlebar as shown in the installation diagram.
• Attach the handguard backbone with the applicable parts to the handlebar end and clamp connector.
• Position the backbone so it is horizontal when viewed from the side.
• Tighten all bolts in the specified order: (10), (9), (4), then (7).

Installation Instructions

View Installation Instructions – BHG-115-00-NP

Warning

Check the operation of all handlebar controls, specifically the throttle, front brake, kill switch, and clutch, to ensure they operate correctly and according to OEM specifications. Do not ride the motorcycle if any controls are not operating correctly or if rear-view mirror vision is obscured.

Check periodically that all bolts remain tight.

Installation Safety

Installation of the handguard is safety-relevant work and can be complicated. Installation by a qualified motorcycle service technician is recommended. Rideworx accepts no liability for damage caused by improper mounting.

All screws, bolts, and nuts, including replacement hardware provided by Rideworx, should be tightened to the torque specified in the fitting instructions. After the first 50 km of riding, check that all screws, bolts, and nuts are tightened to the correct torque. A medium-strength liquid thread-locking product is recommended on all fasteners.

Safety Disclaimer

Failure to follow these fitting instructions could cause serious injury, death, or property damage. These handguards are intended solely for use with motorcycles, ATVs, snowmobiles, and scooters that have not been modified. They are not designed to prevent injury or death while riding or in an accident or crash.

The user must ensure that all controls are free from interference with the handguards every time before riding. By installing and/or using this product, you acknowledge that you accept these terms and have followed the fitting instructions.

What's in the Box?

• Barkbusters Hardware Kit – Two Point Mount BHG-115-00-NP
• Aluminium Handguard Backbone
• Bar End Weights
• Clamps and Connectors
• Mounting Hardware
• Installation Instructions